Avid Technology MediaDock 2 Plus, Setup And User Manual

Page: 20 / 88

20
Power Supply
The power supply in the MediaDock 2+ enclosure supplies power to
both LVD shuttles and the optional device bay.
The power supply has two LEDs that are visible on the front of the
chassis beside the power switch. The green LED is On when power is
on and within specifications. The red LED is On when a thermal fault
is detected.
Figure 1-2 shows the power switch and LED locations on
the MediaDock 2+ enclosure. Descriptions of the LEDs are provided in
Table 1-1 .
LVD Shuttle Features
The MediaDock 2+ enclosure uses only LVD shuttles. These shuttles
are not included with the MediaDock 2+ enclosure, and must be
purchased and installed separately. The LVD shuttles are available in a
variety of storage capacities.
The LVD shuttles use a lever for inserting or removing the LVD shuttle
from the MediaDock 2+ enclosure. The internal drives have a 3.5-inch
form factor and transfer data on a 16-bit data bus. The drive enclosure
provides the cooling, power, and cabling connections.
Each LVD shuttle contains two LEDs that provide information about
the LVD shuttle’s activity (see
Figure 1-4 ). Table 1-2 describes the
function of each LED. The third LED is not used in the MediaDock 2+.