Avid Technology EXPANSION CHASSIS, Instructions For Installing And Using

Page: 51 / 98

I n s t a l l i n g a n d U s i n g t h e A v i d E x p a n s i o n C h a s s i s C h a p t e r 3 • E m p t y C h a s s i s I n s t a l l a t i o n 3 9
Installing Quadra 650/900/950 NuBus Cards
To install the Avid NuBus cards for a Quadra 650/900/950:
1. Determine which NuBus cards you’ll be installing in each slot in the Expansion
Chassis using Table 4.
2. Remove the slot cover from the rear of each slot that you are going to use. Push
the slot cover out from inside the chassis.
3. Install each NuBus card into its slots. Align the connector on the NuBus board
in the Expansion Chassis and the connector on the NuBus card. Apply a gentle
downward force until the card seats in the connector.
4. Attach the ribbon cable(s) that interconnect the two- or three-card JPEG set.
Figure 29: Expansion Chassis NuBus Slot Numbers
Table 4: Quadra 950 and Quadra 650 Card Layout
NuBus Card Slot ID Slot Number
ATTO SiliconExpress IV, IVD 5 or 7 5 or 6
AudioMedia II or SA 4 Interface 4 4
NuVista Card A 8
Enhancement Card or Comm Card B 9
Avid JPEG or Advanced JPEG C 10
Slot Numbers
11 12 1 2 3 4 5 6 7 8 9 10