Avid Technology AirSpeed series, Installation And User Manual

Page: 96 / 282

3 Configuring the Software
96
Configuring Channels for Capturing Ancillary Timecode
This topic contains information on how to configure channels for capturing ancillary
timecode.
To configure channles for capturing ancillary timecode:
1. On the Channel Configuration dialog box, make sure one of your slots is configured for
Ancillary Time Code (ATC), and that it is enabled. This means the Enable check box
must be selected.
2. Highlight a capture channel, and either select Edit > Template, or right-click the
MiniMonitor and select Edit Template.
The Template for Channel (number of channel you selected) dialog box opens.
3. Select the Clip tab.
4. In the TC Src field, select ATC (ancillary time code) from the pull down menu.
5. Click OK.
Your AirSpeed Multi Stream is now set to capture ancillary timecode. To configure your
system for playing out ancillary timecode, see
“Configuring Channels for Playing Out
Ancillary Timecode” on page 96 .
Configuring Channels for Playing Out Ancillary Timecode
This topic contains information on how to configure channels for playing out ancillary
timecode.
To configure channels for playing out ancillary timecode:
1. On the Channel Configuration dialog box, for a selected channel, select the Ancillary
Data Output Enabled? check box.
2. In the VITC Playback Line # field, do one of the following:
t
If you want to play out the timecode that is previously stored in the clip, select
NONE.
t
If you want to regenerate the timecode based on what you have selected for this
channel, select 9.
Your AirSpeed Multi Stream is now set to play out ancillary timecode. To configure
your system for playing out ancillary timecode, see
“Configuring Channels for
Capturing Ancillary Timecode” on page 96 .