Avid Technology AirSpeed Multi Stream, Installation And User Manual

Page: 149 / 398

AirSpeed Multi Stream Workgroup Configuration
149
Configuring Channels for Remote Control with Avid iNEWS Command,
CaptureManager, or Interplay Capture
This topic contains information for configuring AirSpeed Multi Stream channels for remote
control with an Avid iNEWS Command, CaptureManager, or Interplay Capture system.
Before you configure AirSpeed Multi Stream channels for remote control with one of these
systems, all of the hardware and software pertaining to the AirSpeed Multi Stream server
must be installed and configured, including the AirSpeed Multi Stream Device Service
(from the Avid iNEWS Command DVD).
n
Regardless of whether the AirSpeed Multi Stream is a capture and/or playback server, ensure
that it is in the Interplay workgroup. If it is a playback server that will be controlled by
iNEWS Command, it must be configured to join a second workgroup—the same workgroup
as the Command Servers. For more information, see the Avid iNEWS Command
Administrator’s Guide.
n
The AirSpeed Multi Stream Device Service can be configured to be controlled by up to two
Command systems.
To configure Channels for Remote Control with Avid iNEWS Command,
CaptureManager, or Interplay Capture:
1. On the AirSpeed Multi Stream server, launch the Avid Service Configuration
application by selecting Start > All Programs > Avid > Service Framework > Avid
Service Configuration.
2. Configure the AirSpeed Multi Stream Integration Service. Be sure to do the following:
a. Configure Interplay authentication settings
b. Configure the Destination template (for recording and sending to ISIS)
c. Assign a Destination template in the Default Template tab
For more information, see “Configuring the Avid Service Configuration for Interplay
Workgroup” on page 136 .