13
Install horizontal stabilizer
Use a sharp hobby knife to carefully trim the covering around the holes in the fuse
for the stab tube and the bolt holes on each side. Slide the aluminum
tube(supplied) through the fuse, and slide the stabilizers onto the tubes from each
side. Make sure that both stabs are snug against fuse. Using the 6-32 allen
bolts(supplied), attach the stabs to the fuse.
Install the Control Horns
Mount the provided control horns to each
control surface on the hard points. Try and
get the control horn base as close to the
leading edge of the control surface. This will
provide the proper geometry and allow the
control surface to move both directions
equally. For the elevators, place each horn
1” from the fuse, and the exact same dis-
tance from the hinge line. Otherwise, the
geometry will be different and it will be diffi-
cult to adjust the throw amount to be equal
in both directions. (See diagrams below)
Stab
Elevator
