AVIATION DESIGN
- ZI le Chenet - 91490 MILLY LA FORET – FRANCE - Tel : int+ 33 1 64 98 93 93 - [email protected] – www.adjets.com
26
Exhaust tube
Fit the aluminium ring on the exhaust tube.
Rivet the 2 part together.
Insert 3 x M3 screw in the aluminium ring to adjust the
clearance between the engine and the exhaust tube.
The exhaust tube must just overlap the engine exhaust cone.
Fit the exhaust in the fuselage
Screw an aluminium pad on the exhaust to fit it on the main
rear frame
Important : Protect all electric wire with ceramic fiber.
The rear exhaust cone can be fitted with 3 parker screw or with
silicon glue.
FINISHING TIPS
Now you have to remove the wax from all the parts to paint.
The best way to do this is to sand all the surfaces with a "scotch brit" scouring pad used to wash up the
crockery
All the parts can also be sanded with #400 grit paper to remove wax.
Do not apply primer on the fuselage, wings, stabs and fins.
They must be directly painted.
Think light : excessive paint build-up will add unnecessary weight to the model. Apply light, thin coats of
paint and sand between coats to avoid excess weight.
Radio, ECU, batterie, tubing... installation :
Connect all the engine tubing to the fuel pump.
Connect the fuel pump to the fuel tank.
Connect all the engine connector the the ECU.
Connect all the retract tubing according the manual to the air valve.
Connect all radio wire