AVG EZTouch I/O Jr., Manual

Page: 32 / 52

EZTouch I/O
Jr.
32 / 52
Editing IP Address
This section applies only to the units purchased with Ethernet capabilities. Each
EZTouch I/O
Jr. unit with Ethernet comes with a factory-programmed IP Address
that may need edited to be compatible with your LAN network. The serial port
(COM1) , in combination with the editing software, can be utilized to update the IP
Address information.
Serial Port (COM1) Method
1. Insert a RS-232C cable into the serial port (COM1) and launch the editing
software EZPanel Editor.
2. Select Edit Program ON-LINE and enter a project name (e.g. Test). Click OK.
3. Next select
EZTouch I/O
Jr from the drop-down list under Panel Family. Once
EZTouch I/O
Jr. is selected, the other fields will populate.
4. Choose the appropriate I/O model (22 or 28) and click OK to launch the
editing software program. The Main Project Window will then appear
showing both the PLC and Panel sides to the program. To adjust the IP
Address, the Panel side will need to be selected.
5. Click Set-up > Ethernet Set up . A dialog box will appear displaying the current
IP parameters.