INSTALLATION
INSTRUCTIONS
BEFORE STARTING YOUR APPLIANCE, READ AND FOLLOW THESE IMPORTANT INITIAL STEPS.
ELECTRICAL CONNECTION AND CLEARANCE:
This appliance is designed to be free standing only and should not be recessed or built-in.
Place your freezer on a floor that is strong enough to support the freezer when it is fully loaded.
To allow proper air circulation, allocate 20cm (
8’’) of space on each side of the unit, 10cm (4’’) in the
back
and 30cm (12’’) on top of clearance to allow the proper air circulation.
Place the freezer away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct
sunlight may affect the acrylic coating and heat sources may increase electrical consumption.
Extreme cold ambient temperatures may also cause the freezer not to perform properly.
Avoid locating the freezer in humid areas
.
Plug the freezer into a separate, properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord.
Any questions concerning power and/or grounding should be directed toward a certified electrician or
an authorized Service Center.
Do not use this appliance with an extension cord or adaptor
.
Be careful not to damage the shelving grids as they contain refrigerant liquid.
UNPACKING AND CLEANING YOUR APPLIANCE
Remove wrapping, tape and any labels from your appliance before using (except the rating label).
Do not use sharp instruments, rubbing alcohol, flammable fluids or abrasive cleaners to remove tape
or glue. These products can damage the surface of your unit.
Clean your freezer before usage. Use a sponge, cloth or paper towel and mild detergent in warm
water to clean outside and inside of freezer, door liner and gasket. Rinse and dry thoroughly.
Once plugged in, allow the freezer to cool completely for 2 to 3 hours before filling with frozen
food.
19
