ZQ375 Checkweigher User Instructions
31
3.3 Sim375 application
3.3 Sim375 application
This section applies if the Sim375 application is enabled. See the Service manual for
information on enabling the applications.
The SIM375 application is a fast and efficient checkweighing application that displays
the ± deviation from a target point set by the operator.
3.3.1 Checkweighing
Switching Between Checkweighing and Normal Weighing Mode
To switch between checkweighing and normal weighing mode, press
SELECT
. When
the
GROSS
annunciator is displayed, the unit is in normal weighing mode. Press
SELECT
again and the
GROSS
annunciator disappears. The unit is now in
checkweighing mode. The display may show a negative weight and the
Under
segments of the bargraph may be lit if there is an active target value.
Setting a New Target Weight and Simple Checkweighing
1.
With the unit in Checkweighing mode, press
ZERO
to zero the scale and place
an item of the correct weight on the scale and press
TARGET
…
The scale will read
0
weight and the center
Accept
segment will light
showing the target weight has been set successfully.
2.
Clear the scale and place the next item on the scale …
The bargraph will show the item is under the target weight, over the
target weight or on target.
3.
Repeat step
for all the other items to be weighed.
Using Pushbutton or Preset Tare is not available in the SIM375 application
If motion is present for greater than 2-3 seconds after the
TARGET
key press, the
target operation will be aborted and the word
cant
will be displayed briefly.
By default the Target segment lights if the weight is within ± the high and low
tolerance of the target weight. The over and under segments each represent 1
division.
Summary of Contents for ZQ375 Checkweigher
Page 1: ...ZQ375 Checkweigher User Instructions AWT35 500812 Issue AC...
Page 93: ......