B240 Counting Scale User Instructions
15
2.2.2 Installation
1.
Place the scale on a table.
2.
Carefully place the pan pins into the four holes on the top cover.
3.
Adjust the feet to center the bubble level. See
4.
Connect the adaptor pin to the adaptor jack. Adaptor jack is located below the
scale. See
.
5.
Adaptor connects to an AC power socket.
Pluggable equipment must be
installed near an easily accessible socket outlet with a protective
ground/ earth contact.
6.
Press and hold the
ON/OFF
key until the unit beeps to turn it on. (Press and
hold the
ON/OFF
key to turn the unit off.)
7.
Display will start self checking and display will then show normal weighing
mode.
8.
You can start normal operation.
2.2.3 Leveling
Place the scale on a table.
Check the bubble level. If the bubble is not centered, adjust the leveling feet until
centered. Check the level when you change scale locations.
2.2.4 Charging the battery
To charge the battery insert the adaptor pin into the jack located under the scale. Plug
the adaptor into the mains power. The scale will charge without being turned on.
Charge the battery for 12 hours for full capacity before using the scale.
A battery charging status LED is located on the right side of the display. If the LED is
green the battery has a full charge. If it is red the battery is nearly discharged. If yellow
the battery is being charged.
Do not use any other type of power adaptor than the one supplied with the scale. Verify
that the AC power socket outlet is properly protected.
