Avery Dennison Monarch ADTP2 EcoCut, Operator'S Handbook Manual, Page: 40 / 47

6-2 Operator's Handbook
5. Press

or

to increase or decrease the contrast. Increasing the contrast setting
darkens the print; decreasing the contrast setting lightens the print.
Note: Press the left function button to change the amount (adjusts to change by 1, 10,
or 100).
6. When you see the contrast setting you need on the display, press SET to save.
7. Press BACK until you see “Ready,” then press SELECT .
Adjusting the Printhead Pressure Dials
Two dials are located on either edge of the printhead assembly. Use a coin or flathead
screwdriver to adjust the dials
based on the width of your supply
. The “out of the box”
setting (default) is least pressure, which provides optimal printing in most cases.
If you see smudging, ribbon wrinkling, or poor print quality, adjust the printhead pressure
dials.
Note: Both dials must be set to the same position.
Each dial has four settings:
♦
Least pressure
♦
Light pressure
♦
Medium pressure
♦
Most pressure
Knob is set to least pressure adjustment (knobs are up).
Most Pressure
Least Pressure