25
NO111B_NX211B User Manual AVerMedia Technologies, Inc www.avermedia.com
2. Using the commands below in the Linux PC to start re-flashing BSP.
$
sudo
tar zxvf EN715-R1.0.*.tar.gz
(file: EN715-R1.0.*.tar.gz for NO111B/ file: EN715-NX-R1.0.*.tar.gz for NX211B)
$ cd JetPack_*.**/Linux_for_Tegra
$
sudo
./flash.sh Jetson-nano-emmc mmcblk0p1
(For the Xavier NX module:
$
sudo
./flash.sh Jetson-xavier-nx-devkit-emmc mmcblk0p1)
Note: sudo is required to re-flash the BSP.
5.0
Software
For L4T (Linux for Tegra) BSP support and the other software support associated with
NVIDIA® Jetson Nano / Xavier NX , please visit AVerMedia website to contact our technical
support function. (https://www.avermedia.com/tw/support/contact)
6.0
Force Recovery Mode
USB 3.l/OTG port of NO111B/NX211B can be used to re-program NVIDIA
®
Jetson NANO
/Xavier NX by using the other host system running NVIDIA Jetpack, as the procedure described
below.
1.
Power off the system. Ensure the system power must be completely OFF, instead of staying
in the suspend mode or the sleep mode.
2.
Connect a USB cable from OTG USB port to the other host system which will be used to
re-program the new system file into NVIDIA
®
Jetson Nano/ Xavier NX.
3.
Press and hold down Force Recovery Butto
n and then
power on the carrier board.
4.
After three seconds, release Force Recovery Button.
5.
NVIDIA
®
Jetson Nano/Xavier NX will show up on the USB list of the host system as a new
NVIDIA target device.
6.
After the system software is updated successfully, please ensure to power off the system. A
clean power-on will then revert OTG port back to the host mode.
