Mooney M20 series
Installation Instructions
AVE-MOD-012-INS
Issue 02
__________________________________________________________________________________
Aveo Engineering Group
, s.r.o.
Drasov 202, 261 01 Drasov
Czech Republic
Issue of form 01
Page 6 of 21
1.3
Description
This modification is the replacement or new installation of the composite wingtip
segment and of position, anti-collision, taxi- and landing lights by LED type lights.
1.3.1
Wingtip lights
This modification allows on aircraft which already have a composite wingtip to replace
either the complete wingtip or only the light unit inside or outside the original
composite wingtip. The Mooney also exists in versions without a composite wingtip at
all. For those aircraft the light unit can be replaced. Aircraft which originally have no
composite wingtip cannot be equipped with the Aveo wingtip.
Aveo designed a new wingtip with integrated position lights type I and II including the
strobe function.
Alternatively the originally wingtip lights on aircraft with or without wingtip can be
replaced by the Aveo Ultra Galactica embedded without installation or replacement of
the conformal wingtip. The Ultra Galactica embedded also fulfills the requirement for
position lights type I and II plus the strobe function.
1.
Light assembly navigation &
strobe
2.
Wingtip
3.
Landing / Taxi light installation
LH, RH and cowling
4.
Recognition light installation
5.
Beacon installation
6.
Strobe assembly tail
7.
Ice retrofit
Synchronization:
The strobe lights may be synchronized but the frequency of the strobes is so low that
synchronization of the lights is not required.
For the synchronization function the blue wires of each light to be synchronized have
to be connected. If for this function additional wires are to be installed then these
must be installed along the wire bundle in which the lights power wires run. If the
function is not used the blue wire at each light is to be capped and stowed.