10
Installation Diagram of System Transmitter VGA-C5-S
c.
Function Test:
Turn ON your AV device, the
POWER LED
should turn ON green to indicate
the
POWER On
status and the LEDs above RJ45 will blink before VGA signal is turned ON and
remain ON after VGA signal is turned ON.
Receiver VGA-C5-R Installation and UTP Connection
a.
Site Selection:
Place Receiver in an appropriate place and have the UTP cable settled for
later connection.
b.
Power Up:
Plug power adapter to the Receiver and connect monitor and speaker to the VGA
OUT and AUDIO port. The
POWER LED
will turn ON green to indicate the
POWER ON
status.
c.
Selection of UTP Cable:
For best VGA resolution, use Cat5e or Cat6 cable for connection.
The maximum extended length of one section should not exceed 300 meters
(1000 ft). The connector must be made by 568B/568B type.
