www.avenview.com
6
Section 2: Installation
Follow these instructions for installation of SW-DVI-16X16:
1.
Mount or fix the SW-DVI-16X15 safely
2.
Connect the SW-DVI-16X16 to included external power supply (50Hz 200V) through the power cable
3.
If controlling the SW-DVI-16X16 through RS232 port then connect the included RS232 serial cable
4.
Connect RJ45 cable to SW-DVI-16X16
2.1
I/O Connections
Connect the DVI output of the source DVI signal to IN1 ~ IN16 of the SW-DVI-16X16 Matrix Switch. Connect
the DVI cable to output connector of the SW-DVI-16-16.
2.2
Device Operation
2.1.1
Front Panel
2.1.2
Device Power On
SW-DVI-16X16 has a self check with a bell warning when the unit powers on. No command will respond during
10 seconds of initial power on.
This equipment should be used in a main power system with a grounded (neutral)
conductor. The third (grounding) pin is a safety feature, do not attempt to bypass or
disable it.
For safety consideration, please cut off the power supply before replacing signal cable.
Summary of Contents for SW-DVI-16X16
Page 3: ...www avenview com 3...
