www.avenview.com
7
Note for EDID (Extended Display Identification Data) learning continued:
Step 2
– Please turn the rotary arrow clockwise [
] from
Mode 6
to
Mode 1
. If you can get audio/video
from the display, you can stay tune at this setting for 1080p and stereo audio. If you need to get 1080p
with 7.1ch audio output, please turn the rotary arrow counterclockwise [
] from
Mode 1
to
Mode 0
. If
you cannot get the audio/video out normally, please go to next step.
Step 3
– Please turn the rotary arrow counterclockwise [
] from
Mode 0/1
to
Mode 7.
Wait a few
seconds until the LED of the RJ-45 connector dims and then lights again.
Step 4 – Please turn the rotary arrow clockwise [
] from
Mode 7
to
Mode 0/1
. You should have your
desirable audio/video output. If not, please follow the instruction in Note#1.
3. To learn EDID from the HDMI display, please follow the instruction below:
Step 1
– Please connect the display which you want to read EDID with a HDMI cable to the transmitter’s
HDMI IN and set the rotary arrow at
Mode 7
so the TX can learn the EDID information from the connected
display. The LED on the RJ45 connector of TX will dim and light again in a few seconds, which indicates the
EDID learning procedure, is complete.
Step 2
– Please turn the rotary arrow clockwise [
] from
Mode 7
to
Mode 0
or
Mode 1
for desirable
audio setting and enjoy the experience. DO NOT let the rotary arrow pass by
Mode 5
and
Mode 6
which
will erase the EDID just learned and restore the default EDID.
