BlueRiver Manager Software
The BlueRiver Manager is demo control software used to configure and control signal extension and
switching between TX and RX units.
General Information
The BlueRiver NT Manager can be used on any Windows PC using Microsoft .Net framework 4.0
or higher (Windows 7 SP1 or Windows 8.1/10 is recommended).
The PC running BlueRiver Manager can be connected to the GbE port of any Avenview device or to any
RJ45 port of the 10GbE switch except the management/console port of the switch which is not part of the
network. For this evaluation, all Avenview devices should also be connected to the same 10GbE Switch.
Before proceeding, make sure all Avenview devices are powered ON. Then ensure that the PC receives
an IP address in the 169.254.X.X range. If this is not the case, please set your IP address manually in
the169.254.X.X range with a mask of 255.255.0.0. In case of manual setup, make sure to use an address
not currently in use by any TX or RX device.
Start the application by double clicking on BlueRiverNT_Manager.exe file provided by Avenview. If you
receive a pop-up asking for network access confirmation, make sure that both Private and Public networks
are allowed.
Upon launch, the BlueRiver Manager‘s main interface appear as per the picture below:
MANAGER SOFTWARE
www.avenview.com
Page
3