Avenview HDM-C6IP-S, User Manual

Page: 6 / 16

www.avenview.com
Page 3
2. INTRODuCTION
HDM-C6Ip-SET, HDMI extender set is designed to extend your HD display with the resolutions of 1080p/60Hz up to 330 feet
(100 meters) away from your HDMI or DvI-D source. Thanks to the use of the TCp/Ip protocol, you can transfer your high-
definition video over an existing TCp/Ip network. See below three examples:
A: The Tx and Rx units can extend 100 meters over a single CAT5/6 cable connection point to point.
B: The Tx can be connected to a Gigabit switch to establish a Ip address therefore sending 1080p video signals to multiple
Rx connected to the Gigabit switch and the HDMI displays.
C: Multiple Tx’s can be connected to a Managed Gigabit switch with vlAN/IGMp support therefore sending 1080p video
signals to Rx connected to the Gigabit switch to show different sources on the HDMI displays.
• Extends HDMI up to 95m/100m over single CAT5E/6
• Supports HDMI, EDID, Support HDCp
• Supports resolution HDTv / 1080pp/60Hz, vesa (1920 x 1080)
• Supporting the point to point transmission function currently which can be expanded to the multi-point to point
transmission function.
•
Requires a managed Gigabit switch with vlAN/IGMp support to have a soultion with multiple sources (Transmitters).
Standard Gigabit switch can only support one transmitter.
• The managed switch must support port based IEEE 802.1Q vlAN, IGMp, and to allow duplicate Ip addresses across
the vlAN domains.
• Each vlAN acts as independent HDMI over Ip Channel on the network.
•
Number of Tx and Rx that can be used is dependent on bandwidth of the switch (Recommended Gigabit switch
10/1000).
• Managed switches can be cascaded up to 3 levels, allowing the farthest display to be located up to 300 meters away
from the source device. Each receiver can be located up to 100 meters away.
• uses M-JpEG technology to process image compression on a fixed bandwidth.