www.factorybuysdirect.com
200289-01F
12
INSTALLATION
Installing Wall Spacers
1. Place heater on wall mounting bracket.
2. Mark screw locations on wall.
3. Remove heater from mounting bracket.
4. If installing bottom mounting screws into hol-
low or solid wall, install wall anchors. Follow
steps 1 through 4 under
Attaching To Wall
Anchor Method,
page 11. If installing bottom
mounting screw into wall stud, drill holes at
marked locations using 9/64" drill bit.
5. Replace heater onto mounting bracket.
6. Place spacers between bottom mounting
holes and wall anchor or drilled hole.
7.
Hold spacer in place with one hand. With other
hand, insert mounting screw though bottom
mounting hole and spacer. Place tip of screw
in opening of wall anchor or drilled hole.
8. Tighten both screws until heater is firmly
secured to wall. Do not over tighten.
Note: Do not replace front panel at this time.
Replace front panel after making gas connec-
tions and checking for leaks.
Figure 10 - Mounting Heater Onto
Mounting Bracket
INSTALLING OPTIONAL
BASE FEET
1. Align screw holes in base feet to the bot-
tom of the heater. Attach using Phillips
head screws (provided) (see Figure 12).
2. Position the heater to the desired location.
Secure the base feet to the floor by using
two Phillips head screws (provided) (see
Figure 13).
Placing Heater On Mounting
Bracket
1. Locate two horizontal slots on back panel
of heater (see Figure 10).
2. Place heater onto mounting bracket. Slide
horizontal slots onto stand-out tabs on
mounting bracket.
Figure 11 - Installing Bottom Mounting
Screws
Side View
Front View
Side View
Front View
Wall
Spacer
Heater
Mounting Bracket
(attached to wall)
Horizontal Slots
Stand-
Out
Tab
Figure 12 - Attaching Base Feet to Heater
Figure 13 - Securing Heater to Floor
Screw
Hole
Screw
Screw
