General use & adjusting default settings
Follow the procedures described below to adjust your audio settings and
default settings on the Avee microphone add on.
Connect
the
Avee mic
add-on
to the
aircraft
•
Switch on ANR feature on the headphone.
•
Plug the Avee mic add-on into the headset and connect the
interface cable to the aircraft and to the Avee.
•
When the aircraft radio & intercom is switched on, the mic add-
on will get bias power from the aircraft.
This is indicated with 5 flashes on the Avee status led indicator.
If internal Bluetooth
®
is available
in your headset
, the Bluetooth
connection will automatically disconnect when the add-on is
connected to the headset.
Speaker
volume
setting
•
Press
+
or
-
to increase/decrease volume in headphones.
You will see 5 flashes in the add-on status led when you have
reached max or min volume.
Default volume
is MAX when the Avee is connected to the aircraft.
This can however be changed.
Default
volume
setting
The default volume setting on the Avee may be changed from
always maximum level
after it is plugged into the aircraft, or to
remember last setting
. Follow this procedure to change:
•
Press the ‘
+’
and ‘
-‘
for 2 seconds.
•
Release the buttons when you see
5 flashes.
Short flashes:
Volume is set to
remember last setting
when the
Avee connected to the aircraft.
Long flashes:
Volume is set to
maximum
when the add-on s
connected to the aircraft.
Microphone
output
level
Set the microphone output level according to the following:
Ensure the white indicator located by the microphone input is
facing towards your mouth. Place the microphone approx. 6mm
from your mouth at all times.
Speak into the microphone while adjusting the volume.
•
Press & hold the ‘
+’
key for 3
seconds to enter mic volume
level setting mode.
•
By repetitively pressing the ‘
+’
key, you set
the volume from 1 (min) to
(max).
•
The volume level is indicated by a number of led status blinks
corresponding to the mic out level every second.
•
Press the ‘-’ key to leave the mic volume setting. The add-on will
automatically revert to normal operation after 40 seconds.
Automatic
mono &
stereo
mode
Aircraft stereo or mono availability is detected automatically by
the Avee add-on
by default
. It can however be set (next chapter).
This feature works like this:
If no audio is detected in the aircraft right audio channel, the
left channel is switched to both left and right speaker in the
headset.
If audio in the right aircraft channel is detected, the left aircraft
channel is switched to the headset left speaker, while the right
aircraft channel is switched to the right speaker.
Changing
mono &
stereo
mode
The mono & stereo detection mode can be set according to the
following procedure:
Press & hold the ‘
-’
key for 3 seconds to enter stereo setting
mode.
•
By repetitively pressing the ‘
-’
key, you step from mono (1
status led flash) , auto (2 flashes) and ‘always stereo’ setting (3
flashes).
Press the ‘+’ key to leave the mic volume setting. The add-on
will automatically revert to normal operation after 40 seconds.
