User guide AMV 2125-DSP
page 3
11 10 9
1
2
3
4 5
6 7 8
1. Control dial for Gain, THD, Treble, Middle and Bass
The 5 Potentiometer per channel allow following adjustments:
Gain
: The Gain-controller customizes the amplification of the channel to the level of the signal
source of the input.
With the
barrier
controller
the activating sensibility can be adjusted when the microphone will
be activated
With the
3-Band-Equalizer
(hights, middles, depths) the microphone is adapted to the
speaker to achieve an optimized sound.
Treble
:
12 dB at 10 kHz
Mid
:
12 dB at 700 Hz
Bass
:
12 dB at 70 Hz
THD
low noise barrier: a
noise gate
(barrier), which defines the activating sensibility of the
microphones can be adjusted here. The barrier for the 5 microphone inputs are adjusted by a
potentiometer respectively.
2. Gate- und Clippingdisplay (for channel 1
– 5):
Optical display of activated e.g. overdriven
input.
3. Volume control (for channel 1
– 5):
with these volume controls all levels of the signal
sources can be adjusted which are plugged to the microphone/line-inputs (26). During
installation by authorized experts the optimized level will be marked with a sign.
4. Volume control for CD/Aux
5. Depth- and Hights- control for CD/Aux
6.
Volume/Value“-control dial:
control dial with integrated caliper, is used to regulate the
“Master Volume”, i.e. the volume for all outgoing signals.
7
.
„
Preset/Parameter“-control dial:
control dial with integrated caliper is used to access the
different presets.
8. power switch
: by using the power switch the unit can be switched on and off.
9. LCD-Display:
the high luminous display contributes a clear and user-friendly handling.
10. Out State display:
Red: amplifier overdriven at input
Yellow: failure
– when switching on the amplifier the LED flashes short time and disappears
afterwards.
11. channel switch CD/Aux:
Sound carrier selection. The reproducers can be connected at the
backside.
