Avdel 73440-02000, Instruction Manual, Page: 35 / 57

6
Specification
Intent of Use
The pump unit may only be used in accordance with the operating instructions for Avdel ® placing tools and for placing of
Avdel
®
fasteners.
The pump unit is an electrically driven, hydraulic power source. When coupled to a compatible Avdel
® placing tool and
the relevant nose assembly is attached, it can then be used to install a range of Avbolt ® , Avdelok ® , Avseal ® II and
Infalok ® , fasteners in industrial environments.
Refer to the table below for the list of applicable fasteners and associated nose equipment and placing tools.
FASTENER NOSE ASSEMBLY PLACING TOOL
TYPE SIZE PART NUMBER TYPE PART NUMBER
5/16” 73430-03300 AV™10 73430-02000
3/8” 73430-03200 AV™10 73430-02000
73432-03100 AV™15 73432-02000
73433-03100* AV™15 73432-02000
1/2”
73412-03600 AV™30 73434-02000
AVBOLT ®
5/8” 73412-03400 AV™30 73434-02000
AVDELOK ® 3/8” 73430-03100 AV™10 73430-02000
AVSEAL ® II 16 mm 73430-05000 AV™10 73430-02000
73432-03200 AV™15 73432-02000
73433-03200* AV™15 73432-02000
1/2”
73412-03100* AV™30 73434-02000
5/8” 73412-03200* AV™30 73434-02000
3/4” 73412-03300* AV™30 73434-02000
7/8” 73410-03200* AV™50 73435-02000
INFALOK ®
1“ 73410-03100* AV™50 73435-02000
* Nose assembly with jaw release.
The tool is fitted with two Hydraulic Hoses and an electrical Control Cable, 0.6m in length. Additional hydraulic hose and
cable extension lengths are available to order separately as required. Refer to the table below for the available hose
assembly lengths and associated part numbers.
HYDRAULIC HOSE ASSEMBLY
PART NUMBER HOSE LENGTH
07008-00448 5 Metre
07008-00449 10 Metre
07008-00450 15 Metre
The safety instructions must be followed at all times.