Avaya WLAN 8100 Series, Reference, Page: 339 / 382

no qos if-shaper [port <portlist>]
Configuring QoS Policies
Use the following CLI commands to configure QoS policies.
Related topics:
Configuring QoS policies on page 339
Removing QoS policies on page 340
Configuring QoS policies
About this task
Use the following procedure to create and configure QoS policies.
Note: All components associated with a policy, including the interface group, element,
classifier, classifier block, action, and meter, must be defined before referencing those
components in a policy.
Procedure
Create a QoS policy by using the following command from Global Configuration
mode.
qos policy <1-55000> {enable|disable [name <WORD>] {port
<port_list> | if-group <WORD>} clfr-type {classifier | block}
{clfr-id <1-55000> | clfr-name <WORD>} {{in-profile-action
<1-55000> | in-profile-action-name <WORD>} | meter <1-55000> |
meter-name <WORD>}} [non-match-action <1-55000> | non-match-
action-name <WORD>] precedence <1-15> [track-statistics
<individual | aggregate>]}
Variable Definitions
Variable Value
<1-55000> Specifies the QoS policy; range is 1–55000.
enable|disable Enables or disables the QoS policy.
name <WORD> Specifies the name for the policy; maximum is 16
alphanumeric characters.
port <portlist> Specifies the ports to which to directly apply this
policy.
if-group <WORD> Specifies the interface group name to which this policy
applies; maximum number of characters is 32 US-
ACLI reference for wired networks
Avaya WLAN 8100 CLI Reference August 2013 339