Avaya Voice Priority Processor
Installation
4. Configuring the Avaya Voice Priority Processor
During initial setup of the Avaya Voice Priority Processor the IP address is established and the
maximum number of active calls per access point is set. Optionally, you may enter a hostname and a
location for software updates via TFTP.
4.1 Connecting to the Avaya Voice Priority Processor
The initial connection to the Avaya Voice Priority Processor must be made via a serial connection to
establish the Avaya Voice Priority Processor’s IP address. After the IP address is established,
connection to the Avaya Voice Priority Processor may be done via the network using Telnet. It is
recommended that the basic setup actions occur while the serial connection is made.
Connect via the Serial Port
1. Using a DB-9 female, null-modem cable, connect the Avaya Voice Priority Processor to the
serial port of a terminal or PC.
2. Run a terminal emulation program (such as HyperTerminal
™
) or use a VT-100 terminal with
the following configuration:
Bits per second: 9600
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
3. Press Enter to display the Avaya Voice Priority Processor login screen.
4. Enter the default login:
admin
and default password:
admin
. These are case sensitive.
5. The
NetLink
SVP-II System
menu will display.
Connecting Via Telnet
Telnet can only be used after the Avaya Voice Priority Processor’s
IP address is configured.
The Telnet method of connection is used for routine maintenance of the NetLink Server for both local
and remote administration, depending on your network.
To connect via Telnet, run a Telnet session to the IP address of the Avaya Voice Priority Processor.
Once you connect and log in, the
NetLink
SVP-II System
menu displays.
555-301-102, Issue 2
11
July 2003