Avaya programming and use, Installation And Use Manual, Page: 69 / 468

Installation
Installing Telephones
2-37
4. Plug one end of the telephone cord into the jack
in the center of the wall plate (see
Figure 2-32 ).
5. Plug the other end of the telephone cord into
the LINE jack on the bottom of the telephone.
6. Wrap any excess cord around the cord wrap
posts on the bottom inside of the stand.
Figure 2-32. Plugging in the
Telephone Cord
7. To mount the telephone onto the stand, insert
the tabs on the top of the stand into the middle
set of notches on the top edge of the telephone
(see
Figure 2-33 ).
8. Make sure the telephone cord is neatly
wrapped inside the telephone; then rotate the
telephone down until the bottom edge snaps
into position.
Figure 2-33. Mounting the Telephone
onto the Stand
With certain telephones, you can wall-
mount the telephone and use the slide
tray and tray card. Do one of the
following:
■
If you have an 18/18D, 34D, or
Intercom Autodialer telephone,
remove the tray from the “desk” end
of the stand and insert it into the
“wall” end. If a 630B wall plate is
used, the tray hangs down from the
telephone.
■
If you do not use the wall plate with
the 18/18D and 34D telephones, the
tray can slide under the set. To do
this, two mounting holes on the left
and right sides of the stand allow the
tray to slide underneath.
To
LINE
Jack