Avaya programming and use, Installation And Use Manual, Page: 67 / 468

Installation
Installing Telephones
2-35
4. While pressing in the tabs that protrude from
the wide end of the stand, lower the stand to
the telephone (see
Figure 2-28 ).
5. Release the tabs to lock the stand into one of
the three positions provided by the openings
in the back of the telephone. The height of the
stand is adjustable to three positions: low,
medium, and high. The telephone height can
be adjusted by moving the locking tabs to a
different position.
6. Turn the telephone over.
Figure 2-28. Lowering the Stand to the
Telephone
7. Remove the plastic cover from the telephone
(see
Figure 2-29 ). Label the button sheet to
show any programmed lines or button
features, then place the button sheet on the
telephone so the holes fit over the buttons.
Carefully replace the plastic cover.
8. Adjust the swivel display to the desired angle
(low, medium, or high).
Figure 2-29. Removing the Plastic
Cover
ABC
2
DEF
3
1
JKL
5
MN
O
6 TUV
8
WX
YZ
9
0
GHI
4
PQRS
7
*
#
Co
nf
Tran
sfr
Mic
HFAI
Hold
Spk
r
Feature
Mes
sage
Interc
om
Interc
om
Ext.