Using a 2-Slot Carrier
IMPORTANT:
The processor module must already be mounted on the wall. If it is not, refer to the documentation
that came with your system.
Remove the clear, plastic protector from the
connector on the rear of the new module
(and the processor module if you are
upgrading from a stand-alone system) by
grasping the tabs and lifting.
A)
Slide the second module off the processor
module and put it aside.
B)
Slide the new module onto the processor
module, making sure the mounting tracks
interlock.
!
CAUTION:
Do not force the module. If the module
does not insert easily, remove it, clear
any obstruction, and reinsert it.
A)
Label the line and extension jacks.
B)
Connect the line and telephone cords to
the appropriate jacks on the new module.
C)
Route each cord through the hook on the
front of its module.
D)
Connect the free end of each line cord to
the appropriate network interface jack.
E)
Connect the free end of each telephone
cord to the modular connecting blocks for
system extensions.
F)
Gather the line and extension cords
hanging below the hook and twist tie or wire
wrap them.
Tab
Tab
Mounting
Tracks
10
11
12
13
14
15
16
17
1
2
3
ACS
Proc
18
19
20
21
22
23
24
25
4
5
6
308EC
Module
Lines
Extensions
A)
Before starting, remove the power cord
from the wall outlet.
B)
Remove the screw from the bottom of the
wall-mounted module or modules.
C)
If you are upgrading an existing
stand-alone system, skip to Step 4B.
Attach the 2-Slot Carrier to the top right
side of the two modules:
A)
Align the carrier carefully and then push
firmly until the connectors on the modules
snap into the carrier.
B)
Fasten the carrier to the modules using
the two #4 screws included with the carrier.
Press the power cord firmly into the power
jack on the carrier. Plug the other end of the
power cord into a properly grounded
three-prong wall outlet not controlled by a
switch.
If you are replacing the second module in a
2-Slot Carrier, remove the two screws
holding the carrier in place and gently pull
the carrier off the modules.
Re-insert the screw into the bottom of the
modules. Tighten it until the processor
module is flush against the wall. Do not
overtighten or the module will warp.
Check the green lights on the fronts of the
modules:
A)
If a single light is out, power down the
carrier, reseat the module, then power up the
carrier.
B)
If both green lights are out, power down
the carrier, reseat both modules, then power
up the carrier.
C)
If the lights are still out, contact your local
Authorized Dealer or, in the Continental U.S.
only, you may also call the hotline.
1
2
11
4
5
19
3
10
6
18
Lights (LEDs)
1 3
4
5
6
7 8 9
2