Avaya Media Gateway G350, Maintenance Manual

Page: 130 / 332

Avaya Communication Manager controlled maintenance
DIOD-TRK (DIOD Trunk)
130 Maintenance of the Avaya G350 Media Gateway
June 2004
DIOD-TRK (DIOD Trunk)
Many trunk problems are caused by incorrect settings of parameters on the trunk group administration
form. Settings must be compatible with the local environment and with parameter settings on the far-end.
Refer to the Administration Manual for information on how to administer trunks. The Application Notes
section of that book shows the correct settings for administrable timers and other parameters on a
country-by-country basis.
FAIL Internal system error
Retry the command at 1-minute intervals a maximum of 5 times.
PASS Station Audits passed. This Digital Port Media Module is functioning
properly.
If complaints persist, investigate by using other port tests, and by
examining the station, wiring, and connections.
Any NO
BOARD The test could not relate the internal ID to the port.
Check to ensure that the board translations are correct. Translate the board,
if necessary.
Use the
busyout board
command.
Use the reset board command.
Use the
release busy board
command.
Use the test board command. This should re-establish the linkage
between the internal ID and the port.
If the problem persists, replace the circuit pack.
Table 68: TEST#17 Station (Digital) Audits Test 2 of 2
Error
Code Test
Result
Description/ Recommendation
2 of 2
Table 69: DIOD-TRK (DIOD Trunk)
MO Name (in
Alarm Log)
Alarm Level Initial Command to Run* Full Name of MO
DIOD-TRK MAJOR** test port GGGvSpp l DIOD Trunk
DIOD-TRK MINOR test port GGGvSpp l DIOD Trunk
DIOD-TRK WARNING test port GGGvSpp l DIOD Trunk
Note: You must consult local records for the location and designation of the equipment rack
where the G350 is mounted.
**
A MAJOR alarm on a trunk indicates that alarms on these trunks are not downgraded by the
set
options
command and that at least 75 percent of the trunks in this trunk group are alarmed.