1-7/8" DIA
PAPER GASKET
1-5/16" DIA
GREY FIBER WASHER
1-7/8" DIA
STEEL WASHER
1-7/8" DIA
PAPER GASKET
THUMB
SCREW
1-7/8" DIA
PAPER GASKET
1-5/16" DIA
BLACK RUBBER WASHER
1-5/16" DIA
GREY FIBER WASHER
AFTER ASSEMBLY, ALIGN LOGO
AND TIGHTEN SCREW
X X
X X
X
X
X X
X
X
X
X
AFTER ASSEMBLY,
ALIGN LOGO AND
TIGHTEN SCREWS
Figure 3: Speaker Assembly
Figure 4: Assembled Speaker
Drill 5/
1
6” diameter hole for each anchor and screw.
Fold and insert anchor in hole (see Step
1
).
Tap anchor until it is flush with the wall (see Step 2).
Insert red key to pop anchor open behind wall (see
Step 3). DO NOT HAMMER KEY.
Remove key.
Place speaker flange (base) over anchors.
Insert screws and tighten until flush with the mounting
surface. Do not over tighten.
Drill 5/
1
6” diameter hole (minimum hole depth for solid walls
is
1-1
/2”) for each anchor and screw.
Fold and insert anchor in hole (see Step
1
).
Tap anchor until it is flush with the wall (see Step 2).
Place speaker flange (base) over anchors.
Insert screws and tighten until flush with the mounting surface.
Do not over tighten.
Using Anchors with Solid Walls
Using Anchors with Hollow Walls
Page 2 of 2
Installing Anchors
NOTE: Extra gaskets may be included in hardware pack.
