Procedure
1. Press and hold the
*
and
#
keys and insert the battery into the handset at the same
time.
2. Depending on your place of residence:
• Press soft key #1 to start the measurement for a North American site.
• Press soft key #2 to start the measurement for a European site.
The measurement occurs quickly and then the handset display shows the results.
The top line of the display shows the number of clear slots, and the second line of
the display shows the number of clear channels and the associated slots. For
example:
NA Clear Slot: 12 / 12
544333444555 49 / 60
This example indicates the following:
• The survey has completed on a North American site.
• All 12 slots had at least one free channel.
• All five channels were free on slots 1, 10, 11, and 12.
• Four channels were free on slots 2, 3, 7, 8, and 9
• Three channels were free on slots 4, 5, and 6.
Note:
The site should have at least 10 clear slots in order for the D100 to work
properly.
3. Press the soft key used in step 2 to restart the survey. In North America, you can
press soft key 3 to continue with a base station survey. See
on page 35.
Press the
On-Hook
key to return the handset to normal operating mode.
Performing a base station survey
Use the following procedure to confirm that the DECT RF spectrum is not fully occupied by
other DECT base stations in the area.
Note:
The D100 only supports survey mode on North American band frequency.
Overview
D100 SIP Wireless Terminal Installation and Administration Guide
December 2012 35
