[current] setting is the text string associated with the current system value of
DOTIX.
4. To change the setting, press the Right or Left navigation arrow to navigate through
the applicable settings.
Depending on the current value, the deskphone selects the next sequential text
string displays it as the New setting. For example when you change the Pass-thru
mode, if the current value is Pass-thru mode, pressing the Choice Selector causes
the deskphone to display P-t w/Logoff. If the current setting is disabled, pressing
the Choice Selector changes the new setting to Pass-thru mode.
5. Press or touch
Save
to store the new setting and redisplay the Craft Local
Procedures screen.
Using the preinstallation checklist
Before performing static programming of address information, verify that the call system meets
all the requirements listed in the
Requirements to verify for your network
section of the
the pre-installation checklist
on page 14. You can skip item 4., as it refers to the DHCP server.
In addition, you must have the values for the following parameters. To prevent data entry errors
that have a negative impact on your network, obtain and print copies of the following
parameters for each subnet:
• The IP Address of the call server.
• The IP Address of the gateway or the router.
• The IP netmask.
• The IP Address of the HTTP server.
Changing IP address information
About this task
To assign IP addresses to IP deskphones, use the automatic method described in
up and resetting the deskphone (Dynamic Addressing Process)
on page 27. There might be
times, however, when manual assignment of IP addresses is required.
Using Local Administrative Craft Options
46 Installing and Maintaining Avaya IP Deskphone H.323 9608, 9611G, 9621G, and 9641G
August 2013