Avaya G700, Installing And Upgrading, Page: 174 / 808

Installing a new G700 with an S8300 using the Avaya Installation Wizard
174 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
Administering an S8300 primary controller
!
CAUTION:
CAUTION:
This administration applies only to an S8300 primary controller, which may be the
S8300 Media Server resident in the G700 you are installing or may be an
external S8300 Media Server somewhere else in the customer’s network.
If the S8300 Media Server you just installed is configured as an LSP, do not
perform this administration on it. Translations are automatically copied to this
LSP from the external S8300 primary controller.
Skip this section and go to Administering an S8400, S8500, or S8700-series primary
controller on page 179 if the primary controller is an S8400, S8500, or S8700-series Media
Server.
This document covers only the administration of Communication Manager required for the
G700 media gateway to communicate with the primary controller over a customer’s network.
For the majority of administration required, see
Administrator Guide to Avaya Communication
Manager , 03-300509, or Administration for Network Connectivity for Avaya Communication
Manager , 555-233-504.
In this section, you will use the SAT interface to:
●
Assigning Node Names and IP Addresses for the LSPs
●
Administering Network Regions
●
Associating LSPs with Network Regions
●
Administering IP Interfaces
●
Identifying LSPs to the S8300 primary controller
!
CAUTION:
CAUTION:
Before continuing, be sure you have saved translations in Communication
Manager.
Begin by resetting the system.
To reset the system
1. Access the server’s command line interface using an SSH client, like PuTTY, and an IP
address of 192.11.13.6 .
2. Log in, and open a SAT session (type sat or dsat ).
3. At the SAT prompt, type
reset system 4
The system reboots.
4. After the reboot is complete, SSH to the S8300, login, and open a SAT session.