76
Installing the Avaya™ S8700 Media Server with Avaya™ G600 Media Gateway
May 2003
gateway B. The opening in the gasket must be toward the rear of the cabinet. Once installed, the
top media gateway should rest on and compress the gasket.
After the media gateways are mounted and cabled in the rack, proceed to
.
Check AC Power
Each G600 media gateway uses an auto-ranging (85 to 264 volts AC) power supply, 47 to 63
hertz, 330 watts, 4.5 amps (100 to120 volts AC) or 2.3 amps (200 to 240 volts AC), at 500
volt-amps.
The AC power source can be 1 phase of 120 volts AC with neutral (100 volts AC for Japan)
with 15-amp circuit breaker, or 1 phase of 220 or 240 volts AC (200 volts AC for Japan) with
10-amp circuit breaker. The AC cord uses a NEMA 5-15P plug or an IEC 320 plug.
Before powering up the system, check the AC power in the equipment room using a KS-20599
digital voltmeter (DVM) (or equivalent).
To check AC power:
1
Measure the AC voltage between the hot and neutral sides of the receptacle.
2
Depending on the AC power source, verify that the meter reads 90 to 132 volts AC or
180 to 264 volts AC. If not, have a qualified electrician correct the problem.
3
Measure the voltage between the neutral and ground sides of the receptacle.
4
Verify that the meter reads 0 volts AC. If not, have a qualified electrician correct the
problem.
5
When finished, set the AC main circuit breakers to OFF.
Approved grounds
Refer to the job aid entitled
.
Uninterruptible Power Supply
A recommended Uninterruptible Power Supply (UPS) may be used for power holdover. The
type of UPS depends on the holdover requirements. Total holdover capacity varies depending
on the UPS. The UPS must provide surge protection for the media gateway.
!
CAUTION:
The major alarm contacts are designed to be connected ONLY to a UPS that can indicate
that it is on backup power. For most non-Avaya UPSs, you should not use the major
external device leads.
