OSPF
Issue 1 January 2008
619
ip ospf dead-interval
Use the
ip ospf dead-interval
command to configure the interval before declaring the
neighbor as dead. Use the
no
form of this command to set the dead-interval to its default value.
Syntax
ip ospf dead-interval
seconds
no ip ospf dead-interval
Parameters
User Level
read-write
Context
interface:Serial (DS1 PPP L2-L3, DS1 PPP L3, DS1 FR-SUB L2-L3, DS1 FR-SUB L3,
USP PPP L2-L3, USP PPP L3), FastEthernet (L2-L3, L3, PPP L2-L3, PPP L3), VLAN (L2-L3,
L3), Loopback (L2-L3, L3), Tunnel (L2-L3, L3), Dialer (L2-L3, L3)
Example
To specify an interval of 15 seconds to wait before declaring a neighbor dead:
G450-001(if:Vlan 1)# ip ospf dead-interval 15
Related Commands
,
ip ospf network point-to-multipoint
Parameter
Description
Possible
Values
Default
Value
seconds
The interval in seconds
1-415029
40
Summary of Contents for G450 Manager
