Avaya G450 Manager, Cli Reference Manual, Page: 532 / 1334

CLI Commands LLDP
532 Avaya G450 CLI Reference
set lldp system-control
Use the
set lldp system-control
command to enable or disable the LLDP application
globally (per device or stack).
Syntax
set lldp system-control {enable | disable}
Parameters
User Level
read-write
Context
general
Example
To enable the LLDP application globally:
G450-001(super)# set lldp system-control enable
Related Commands
set lldp re-init-delay , set lldp tx-delay , set lldp tx-hold-multiplier , set lldp tx-interval , set port lldp ,
set port lldp tlv , show lldp , show lldp config , show port lldp config , show port lldp vlan-name
config
set lldp tx-delay
Use the
set lldp tx-delay
command to set the minimal delay in seconds between
successive LLDP frame transmissions, on each port.
The tx delay should be in the range 1 <= TxDelay <= (0.25 * TxInterval)
Parameter Description Possible
Values Default
Value
enable
Keyword specifying to enable the LLDP
application
disable
Keyword specifying to disable the LLDP
application