Avaya ERS 8600 series, Configuration Manual

Page: 199 / 420

Chapter 12: IPv6 DHCP Relay configuration
using the CLI
Dynamic Host Configuration Protocol (DHCP) provides host configuration information to the workstations
dynamically. Use the DHCP relay commands to set DHCP relay behavior on a port or on a VLAN.
This section describes the CLI commands for IPv6 DHCP Relay configuration functions in the Avaya
Ethernet Routing Switch 8800/8600.
To configure DHCP Relay, you can use the config ipv6 dhcp-relay command, which allows you to specify
the IP address of the port or VLAN to use as a relay agent, or use the
config {vlan <vid> |
ethernet <ports>} ipv6 dhcp-relay
command to explicitly specify the port or VLAN to use as
the relay agent.
IPv6 DHCP relay configuration navigation
• Job aid: Roadmap of IPv6 DHCP Relay CLI commands on page 199
• Configuring an IPv6 DHCP relay interface on page 200
• Configuring IPv6 DHCP relay on a port or VLAN on page 202
• Showing IPv6 DHCP relay information on page 203
• Showing IPv6 DHCP relay information for a port or VLAN on page 204
Job aid: Roadmap of IPv6 DHCP Relay CLI commands
The following table lists the IPv6 DHCP Relay commands and their parameters that you use
to complete the procedures in this section.
Table 14: IPv6 DHCP Relay configuration commands
Command Parameter
config ipv6 dhcp-relay info
create-fwd-path agent <value> server
<value> [state <value>]
Configuration — IPv6 Routing November 2010 199