Avaya CallPilot 703t, Hardware Installation, Page: 46 / 52

Note:
The parallel port is also known as the printer port or LPT1. It is located at the back
of the server. See the diagram on Rear panel on page 39.
2. If the software feature key is not pre-installed on the dongle, remove it from the
plastic bag and carefully insert it into the software feature slot on the dongle. Make
sure that the clips secure it properly and that the Avaya logo faces outwards.
3. Plug the male end of the adapter into the parallel port.
4. Tighten the connector screws.
What is next?
Continue with Connecting the server to power on page 46.
Connecting the server to power
Before you begin
Ensure that proper power and grounding are available for all the power outlets serving the
CallPilot server and its associated peripherals. Power for these devices must be wired and
fused independently of all other receptacles and referenced to the same ground as the PBX
system.
A qualified electrician must implement the single-point ground reference as required among
the power outlets of the CallPilot server, its associated peripherals, and the power outlets of
the switch.
Provide a sufficient number of properly grounded power outlets or power bars for all equipment.
The single-point ground (SPG) required by the system can be an isolated ground (IG) bus or
AC equipment ground (ACEG) bus in the service panel or transformer. The system must be
connected to safety ground/protective earth in accordance with NEC requirements. For
international use, the system must be connected to safety ground/protective earth in
accordance with Paragraph 2.5 of EN60950/IEC950.
Note:
Refer to Large System: Planning and Engineering for a complete description of approved
ground sources and methods. Insulated ground wire must be used for system grounding.
Installing the server and connecting the peripheral devices
46 Avaya CallPilot® 703t Server Hardware Installation December 2010