Avaya CallPilot 600r, Maintenance And Diagnostics, Page: 85 / 106

Meridian 1 and CallPilot Server Configuration Guide (NN44200-302) for
information about connecting your DS30 cables.
Replacing the DVD-ROM/CDRW drive
Your 600r server comes with a DVD-ROM/CDRW drive installed. The DVD drive is not hot-
swappable. You must power down the system to replace the DVD drive.
You must also remove the server cover and the front bezel to replace the DVD drive.
Requirements
You need a Phillips (cross head) screwdriver, #1 and #2 bits.
To replace the DVD drive
1. Power down the server, unplug all peripheral devices and Ethernet cables, and
disconnect the AC power.
2. Remove the server cover. For instructions, see Removing and replacing the server
cover on page 74.
3. Remove the front bezel. For instructions, see Removing and replacing the front
bezel on page 73.
4. Attach the ESD strap to your wrist and attach the other end to a known grounded
connection.
5. At the rear of the DVD-ROM drive, push outward on the cable retention clips on
each side of the DVD-ROM data cable. Releasing the retention clips pushes the
connector from the drive.
6. At the rear of the DVD-ROM drive, press inward on the cable retention clip at the
right side of the DVD-ROM power cable. While holding the retention clip in, pull the
power cable from the drive.
7. Loosen the blue captive screw at the left side of the DVD-ROM drive assembly.
8. Slide the DVD-ROM drive assembly from the chassis.
Note:
There are no cables to disconnect.
Replacing the DVD-ROM/CDRW drive
Avaya CallPilot® 600r Server Maintenance and Diagnostics December 2010 85