Avaya CallPilot 600r, Maintenance And Diagnostics, Page: 74 / 106

Figure 14: Front bezel
Loosen the thumbscrew fasteners (A) on both sides of the front bezel. You cannot
remove the screws from the front bezel. For more details, see Figure 14: Front
bezel on page 74.
Caution:
Risk of equipment damage
Support the front bezel while loosening the thumbscrew fasteners, as the front
bezel is not held onto the front panel with another mechanism.
2. Hold the front bezel by the thumbscrew fasteners and lift the bezel towards you.
Place it in a secure location while you service the server.
To replace the front bezel
After the Avaya CallPilot
®
server maintenance is complete, replace the front bezel.
1. Align the thumbscrew fasteners on the front bezel with the threaded holes in the
front panel.
2. Tighten the thumbscrew fasteners.
Removing and replacing the server cover
Remove the server cover if you need to service the interior of the server.
To remove the server cover
1.
Voltage:
Risk of electric shock
High current inside the chassis can cause severe injury.
Replacing basic chassis components
74 Avaya CallPilot® 600r Server Maintenance and Diagnostics December 2010