Avaya Cajun P580, User Manual, Page: 537 / 770

Document No. 650-100-700, Issue 1 19-7
Configuring AppleTalk Routing
5. Click Apply to add the new AppleTalk interface, or CANCEL to restore
previous settings. Once you click Apply, you are returned to the
AppleTalk Interfaces dialog box (
Figure 19-4. )
Figure 19-4. AppleTalk Interfaces
CLI Commands
Use the following CLI commands in interface mode to create an AppleTalk
interface:
(config-if:<interface-name>)# appletalk cable-range <cable-
range>
(config-if:<interface-name>)# appletalk address <network.node>
(config-if:<interface-name>)# appletalk zone <zone-name>
(config-if:<interface-name>)# appletalk vlan <vlan-id>
Editing AppleTalk Interfaces
You can edit AppleTalk interfaces using either the Web Agent or the CLI.
Web Agent
Procedure
To edit an AppleTalk interface using the Web Agent:
* Note: You must enable AppleTalk globally and create an AppleTalk
interface before you can edit an interface. See “ Enabling
AppleTalk Global Routing ” and “ Creating an AppleTalk
Routing Interface ” earlier in this chapter.
1. Select Interfaces from the Routing > AppleTalk > Configuration
group on the Web Agent window. The AppleTalk Interfaces dialog box
opens (
Figure 19-6 ).
2. If there is no zone to select or if you want to edit the zones available,
complete this step through step x. If not, skip to step x+1. Select Edit
Zone to edit the AppleTalk zone for this interface. The Edit AppleTalk
Zone dialog box opens (
Figure 19-5 ).