Avaya Cajun P580, User Manual, Page: 527 / 770

Document No. 650-100-700, Issue 1 18-11
Configuring the IPX SAP Protocol
Filter 2
Filter 2 ensures that all networks and service types are filtered for the
indicated interface.
1. Select Net Filters from the Routing > IPX > SAP group on the Web
Agent window. The IPX SAP Net Filters dialog box opens ( Figure 18-
4 ).
2. Click CREATE to create a new filter. The Add IPX SAP Net Filter
dialog box opens ( Figure 18-5 ).
3. Configure the following parameters:
a. Select an interface name from the Interface pull-down menu.
b. Enter 1 in the Precedence field.
c. Enter ffffffff (which represents all networks) in the Net field.
d. Enter ffff (which represents all services/types) in the Type field.
e. Select Inbound from the Direction pull-down menu.
f. Select Enable from the Filter/Suppress pull-down menu.
g. Enter 0 in the Hops field. Entering 0 ensures that there is no
override in the transmission of data on the network.
4. Click APPLY to save your changes, or CANCEL to restore previous
settings.
CLI Command
To create IPX SAP Network filters using the CLI, enter the following
command from Interface mode:
(config if-<interface name>)# ipx
sap-network-filter <precedence> <filter-network>
<service-type> {outbound|inbound | both}
{filter|allow} [<filter-hops>]
Interpreting IPX SAP Interface Statistics
You can interpret IPX SAP interface statistics using either the Web Agent or
the CLI.
Web Agent
Procedure
To interpret IPX SAP interface statistic using the Web Agent:
1. Select Interface Statistics from the Routing > IPX > SAP group on the
Web Agent window. The IPX SAP Interface Statistics dialog box
opens (
Figure 18-6 ).