Avaya Cajun P580, User Manual, Page: 454 / 770

15-4 User Guide for the Avaya P580 and P882 Multiservice Switches, v6.0
Chapter 15
2. See Table 15-1 to configure the OSPF Global Configuration dialog box
parameters:
Table 15-1. OSPF Global Configuration Dialog Box Parameters
Parameter Explanation
OSPF Select to enable or disable OSPF globally on your switch.
Router ID Specify the Router ID on the switch. The router ID is a 32-
bit number assigned to each router running OSPF. This
number uniquely identifies the router within an
Autonomous System. If 0.0.0.0 is used, the router uses the
IP address of an interface.
AS Border
Router Displays the Autonomous System Border Router (ASBR)
status. The switch automatically detects the ASBR status:
• If route redistribution filters are configured for OSPF,
the ASBR status is Enable.
• If all interfaces on the switch are in an OSPF stub area,
the ASBR status is Disable, regardless of whether
route redistribution filters are configured.
For more information on route redistribution filters, see
“
Configuring Route Redistribution ” in Chapter 12 ,
“ Configuring IP Routing .”
SPF Hold Time Specify the minimum number of seconds between SPF
(shortest path first) runs.
SPF Suspend Specify the number of nodes to process SPF runs before
suspending.
Auto-Creation
of Virtual Links Enable or disable the function of automating the creation of
virtual circuits based on network topology. This feature is
Avaya proprietary and only auto creates virtual links on the
config. notes.
Maximum
Number of
Paths Configure the maximum number of paths used when
running OSPF.
Local Ext Type Specify whether imported local routes are advertised in
OSPF with type 1 (internal) or type 2 (external) metrics.
RIP Ext Type Specify whether imported RIP routes are advertised in
OSPF with type 1 (internal) or type 2 (external) metrics.
Static Ext Type Specify whether imported high preference static routes are
advertised in OSPF with type 1 (internal) or type 2
(external) metrics.
Static Low Ext
Type Specify whether imported low preference static routes are
advertised in OSPF with type 1 (internal) or type 2
(external) metrics.