Avaya Cajun P580, User Manual, Page: 441 / 770

Document No. 650-100-700, Issue 1 14-3
Configuring RIP Routing
3. Click APPLY to save your changes, or CANCEL to restore previous
settings.
CLI Commands
To configure or modify the RIP parameters globally on your switch using
the CLI, enter the following commands in router:rip mode:
(configure router:rip)# timers basic <update>
<invalid> Update Timer <Msec>
<Range:Min=10,Max=50>
(configure router:rip)# output-delay <delay>
(configure router:rip)# triggered updates <CR>
<enable,disable>
Modifying RIP Interfaces
You can modify RIP interfaces from either the Web Agent or the CLI.
Web Agent
Procedure
To modify RIP interfaces using the CLI from the Web Agent:
1. Select Interfaces from the Routing > IP > RIP group on the Web Agent
window. The RIP Interfaces dialog box opens ( Figure 14-2 ).
Figure 14-2. RIP Interfaces Dialog Box
Triggered
Updates Disable or Enable route updates that were triggered by a
topology change in the network to be added to the routing
table. The default is Enable.
Update Pkt
Delay Enter the value (in seconds) that represents the time delay
between successive RIP update packets to the neighbor, when
the update requires multiple packets. The default value is 1
second. The parameter range setting is 0-50 seconds.
Table 14-1. RIP Global Configuration Dialog Box Parameters
Parameter Allows you to...
2 of 2