Avaya Cajun P580, User Manual, Page: 155 / 770

Document No. 650-100-700, Issue 1 5-21
Configuring SNMP
ATM Module
Community String
To delete a community string for the ATM-Uplink module, use the
following command:
(configure)#
no snmp-server atm-community <community-string>
[<ip-addr>]
Table 5-12
provides an explanation of the command variables.
Setting the Administrative Contact
CLI Command
To set the administrative contact for the switch, use the following CLI
command:
(configure)#
snmp-server contact <contact-name>
The switch displays the administrative contact when you enter the show
snmp command. For information on this command, see “
Viewing the
SNMP Status .”
Table 5-13 provides an explanation of the command variable.
SNMP
To set the administrative contact for the switch, use the sysContact object,
OID 1.3.6.1.2.1.1.4.
The complete path to this object is:
iso(1).org(3).dod(6).internet(1).mgmt(2).mib-2(1).system(1).
sysContact(4)
Table 5-12. no snmp-server community Command
Parameter Definition
<community-string> The community string that you want to delete.
[<ip-addr>] The IP address from which you want to remove
access to the community string.
Table 5-13. snmp contact Command
Parameter Definition
<contact-name> The name of the administrative contact for the switch.
The contact name can range from 1 to 127 characters.