Avaya BSGX4e, Installation Manual

Page: 23 / 56

23 BSGX4e Business Gateway Installation Guide
NN47928-303 Release 01.01
New Password:
8. Enter the new password.
New Password: ************
The unit responds:
Verify Password:
9. Reenter the new password.
Verify Password: ************
If the new password is reentered correctly, the unit responds:
Changed password for 'nnadmin'
*ICAD*>
Note: A command prompt containing asterisks (
* ICAD *>
) indicates that the
configuration is changed, but not yet saved to nonvolatile memory;
unsaved changes are lost if power is interrupted or the unit is
restarted.
10.To save the password change, enter:
*ICAD*> save
The unit responds:
Saving:....:.:.:.:.:.:.:....:.:..:.:.:.:.:.:.:.:.:.:.:.:.:...
.....:.........:.:.:.:.:.:.:.:. (9648 bytes)
completed!
Initializing the WAN connection
This section assumes that the BSGX4e unit is physically installed and that a terminal
session from the console has successfully logged on to the unit. The final step in the
BSGX4e installation is the initialization of the WAN network connection.
As described in the section Getting network information (page 17) , if the DHCP
service is working properly on the WAN, the BSGX4e receives its IP addressing
information automatically from the DHCP server. Thus, the first step is to ensure
that the BSGX4e has the necessary IP addresses.
If the BSGX4e did not receive its IP addresses automatically, you need to manually
enter the addresses. This minimum network information is listed in
Table 5 (page
18) .
IP Address/Mask for eth0
1. To check that the unit received the IP address and subnet mask for its WAN
interface (called eth0 for Ethernet interface 0), enter: