Avaya 4524GT, Configuration Manual

Page: 144 / 362

Variable definitions
The following table defines optional parameters that you can enter after the
show tdr test
command.
Variable Value
<WORD> Specifies a port or list of ports.
Enabling Autotopology
Use ACLI to configure the Enterprise Autotopology protocol.
For more information about Autotopology, see http://www.avaya.com . (The product family for
Enterprise and Autotopology is Data and Internet.)
To enable autotopology using ACLI, see the following sections:
• autotopology command on page 144
• no autotopology command on page 144
• default autotopology command on page 145
• show autotopology settings command on page 145
• show autotopology nmm-table command on page 145
autotopology command
The
autotopology
command enables the Autotopology protocol.
The syntax for the
autotopology
command is
autotopology
Run the
autotopology
command in Global Configuration command mode.
no autotopology command
The
no autotopology
command disables the Autotopology protocol.
The syntax for the
no autotopology
command is
no autotopology
Run the
no autotopology
command in Global Configuration command mode.
System configuration using ACLI
144 Configuration — System April 2011