Avaya 4524GT, Configuration Manual

Page: 131 / 362

Important:
The Last Saved time is not available even if SNTP is active. ERS4500 switch does not have
a RTC (Real Time Clock).
Run this command in Global Configuration command mode.
copy config nvram block command
This command copies the current configuration to one of the flash memory locations. The
syntax for this command is
copy config nvram block <1-2> name <block_name>
Table 47: copy config nvram block parameters on page 131 outlines the parameters for this
command.
Table 47: copy config nvram block parameters
Parameter Description
block <1—2> The flash memory location to store the configuration.
name <block_name> Name to attach to this block. Names can be up to 40 characters
in length with no spaces.
Run this command in Global Configuration command mode.
copy nvram config block command
This command copies the configuration stored in flash memory at the specified location and
makes it the active configuration. The syntax for this command is
copy nvram config block <1-2>
Substitute
<1-2>
with the configuration file to load.
This command resets the switch to reset so that the new configuration load.
Run this command in Global Configuration command mode.
Configuring system IP addresses and boot mode
Configure, clear, and view IP addresses, gateway addresses, and boot mode information . For
details, see:
• ip address command on page 132
• default ip address command on page 133
General switch administration using ACLI
Configuration — System April 2011 131