Avaya 4524GT, Configuration Manual

Page: 128 / 362

Set power usage threshold
The
poe-power-usage-threshold
command sets the power usage threshold in
percentage on individual units.
By setting the PoE power threshold, you can set a percentage of the total PoE power usage
at which the switch sends a warning trap message. If the PoE power usage exceeds the
threshold and SNMP traps are configured appropriately, the switch sends the
pethMainPowerUsageOnNotification trap. If the power consumption exceeds and then falls
below the threshold, the switch sends the pethMainPowerUsageOffNotification trap.
The syntax for the
poe-power-usage-threshold
command is
poe poe-power-usage-threshold [unit <1-8>] <1-99>
Table 46: poe-power-usage-threshold parameters on page 128 outlines the parameters for
this command.
Table 46: poe-power-usage-threshold parameters
Parameter Description
unit <1 - 8> The unit for which to set the power threshold.
<1 - 99> 1—99 percent
Run the
show poe-main-configure
command in Global Configuration command mode.
Setting PoE detection method
The
poe-pd-detect-type
command enables either 802.3af or Legacy compliant PD
detection methods.
The syntax for the
poe-pd-detect-type 802dot3af_and_legacy
command is
poe poe-pd-detect-type [unit <1-8>] {802dot3af |
802dot3af_and_legacy}
Run the
poe-pd-detect-type 802dot3af_and_legacy
command in Global
Configuration command mode.
Show port power status
The
show port power status
command displays the power configuration.
The syntax for the
show port power status
command is
System configuration using ACLI
128 Configuration — System April 2011