CHAPTER 5
Instructions, use and maintenance manual
Page 30
D r a g o P Z e r o
5.3. TRANSPORT AND HANDLING
AVANZINI BRUCIATORI s.r.l., uses the most appropriate packing and fastening materials based on machine
type and mode of transportation to ensure the machine is not damaged during shipping.
The handling procedures described in this paragraph shall be carried out by staff trained for such operations;
suitably trained personnel to safely perform loading, unloading and handling operations of parcels by means of
lifting equipment, and aware of accident-prevention rules.
CAUTION!
Fragile components and equipment must be packed so as not to be damaged during transport.
CAUTION!
AVANZINI BRUCIATORI s.r.l. is not responsible for any damage to persons or property stemming
from accidents caused by failure to follow the instructions laid out in this chapter and those which
follow.
CAUTION!
The machine must be installed according to the layout agreed upon with the manufacturer.
5.3.1. INFORMATION ABOUT TRANSPORT AND HANDLING
CAUTION!
Considering that the installation operations (including assembly and start-up) require specific
knowledge of the machine and may pose risks for unqualified personnel, the manufacturer requires
that the machine be handled and installed, at the customer’s premises, only by personnel who are
qualified or trained by AVANZINI BRUCIATORI s.r.l.
Before installing the machine and therefore before any handling is carried out, verify that:
• the stability of the load does not lead to danger and/or accidents;
• the means of transport and logistics structures are suitable for this purpose (that they are suitable for the
maximum capacity, for example) and in perfect operating conditions;
• the operators are equipped with suitable personal protection equipment;
• the installation surface is large enough, considering the extra space required for assembly;
• the utility connection points are set up as per attached diagrams (and agreed upon with the Customer);
• the area is set up for installation and the access routes are clear of any obstructions;
•
the height and width are sufficient for passage (leave at least a distance of 1000 mm from walls, pillars, and
anything that may become an impediment to maintenance or escape in case of need);
Observe the precautions and warnings listed below in order to guarantee stability, thus avoiding risks related to
the handling of the machine.
