Avanti STW16D0W, Instruction Manual

Page: 13 / 56

13
OPERATING YOUR PORTABLE WASHER
PREPARATION
1. Connect the water inlet hose
to the water faucet. Don’t
switch on the power if the
water pressure is lower than
0.05MPa and higher than
0.5MPa.
2. Ensure the drain hose has
been installed properly.
3. Insert the plug into the
socket. For safety the plug
should have ground
connection. 4. Insert the end of drain hose
into the hook shelf, and hang
the drain hose over a drain
outlet.
5. Open the water faucet.
6. Put the wash load into the
tub evenly. 7. Add the suitable quantity
detergent into the detergent
case. 8. Close the lid. Otherwise the
washer will not wash or spin,
and alarm will sound.
BEFORE WASHING
Prepare the wash load. Mix large and small articles in a load to get the best washing results.
Drop articles loosely into the inner tub. Do not pack articles in or wrap them. Articles should move
freely through the wash water for best cleaning results. Articles should rollover, sink and then
reappear.
When washing very large articles, do not fill inner tub as full as with other loads. The water level in
your washer should fit the size of your wash load. Small load will use lower water levels. There must
be enough water in the inner tub to allow articles to move and turn over freely. Overloading the inner
tub can result in poor washing and rinsing. Overloading may also cause wrinkling and tearing of
articles.
WATER LEVEL
WATER LEVEL
Right Wrong